INFORMATION SHEET

PROJECT TITLE Project No; 14

Blockwork ‘T’ Junction CORE

1 of 1

Bonding to ‘T’ Junctions.

Bonding to ‘T’ Junctions

As with returns in blockwork the minimum overlap on ‘T’ junctions should be a quarter of a block. This is achieved by building the 100mm piece on alternate courses. The amount of cutting will be determined by the position of the indent in relation to the blocks in the main wall.

Diagram.

Junction in the centre of block in main wall.

Diagram.

Junction position off centre reduces the amount of cutting to be done.

The off cut from course 1 can be used in course 2.